ITA - ENG
Technological systems design
Trainings, specializations, refresher courses
- Lightning and surge protection course according to SPD / CEI 81-10 (IEC 62305)
- Lightning risk assessment course according to CEI 81-10 (IEC 62305)
- Combustible dust and gas explosion risk assessment course according t IEC 31-35 / 31-56
- Course for selection of installed protections in a system
- Indoor workplace lighting course according to EN 12464
- Course “Fundamentals of design/projects galleries” held in November 1991 at the International Centre for Mechanical Sciences in Udine
- “Safety of Installations in Civil and Industrial Buildings” course organized by the Federation of Regional Associations of Engineers of Marche in September and October 1992
- Course “Specialization in Fire Prevention”, authorized by the Ministry of the Interior and organized by the Federation of Regional Associations of Engineers of Marche in March and June 1995
- Training “Head of the prevention and protection of the workplace” according to Legislative Decree no. 626 of 19/9/1994, organized by Assindustria of Ascoli Piceno in November and December 1995
- Refresher course “Project Management and Urban Planning”, held in the Institute of Regional Planning of the Faculty of Engineering of the University of Ancona on 27-28-29 of February 1996
- Training “Renovation of the residential and historic buildings” organized by the Order of Engineers of the Province of Ascoli Piceno in May 1996
- Refresher course “New technical standards for construction (semi-probabilistic limit state method and EUROCODE 2)” organized by the Order of Engineers and Architects of the Province of Ascoli Piceno and Teramo, and by ‘ ATECAP (Association of Economic Technical Readymix Concrete), in September 1996
- Training on new Technical Regulations for Construction (Ministerial Decree of 14/01/2008), organized by the Order of Engineers of the Province of Ascoli Piceno, in February – July 2009
- Refresher course Instructions for Seismic safety reliability assessment – retrofitting of existing buildings. The new CNR 212/2013 – Organized by the Order of Engineers of the Province of Fermo in July 2014
Qualifications
- Fire prevention DPR 151 of 01-08-2011 and DM 05-08-2011
- HSE Manager according to Legislative Decree DLGS 81/08 and S.M.I.
- KNX Partner
Hardware equipment
In order to provide a complete and complex services, EMS is equipped with following tools:
- Illuminance measurement tools
- Electrical installation testing tools
- Relay tester (medium and low voltage)
- Thermographic camera